Dutton-Lainson Company

2000 lb worm gear winch with split drum, allowing cable to pull from opposite directions. Reel automatically stops turning whenever cranking is stopped, locking load in place. Powder coated copper bronze finish, permanently lubricated bearings. Handle included.

2000 lb worm gear winch with split drum, allowing cable to pull from opposite directions. Loop drive can be operated by shepards hook, and if desired, by a variable speed power drill. Reel automatically stops turning whenever cranking is stopped, locking load in place. Powder coated copper bronze finish, permanently lubricated bearings.

2000 lb Worm Gear Winch with 5/8 inch hex drive. Comes with mating handle that can be removed easily without tools. Also allows the winch to be operated with a power drill hooked directly to the drive shaft. Cable capacities: 7/32 in (up to 82 ft)... 1/4 in (up to 59 ft)... 9/32 in (up to 49 ft). Smaller or larger cable diameters are not recommended.

Similar to 10970, but has the ability to accept a 2 inch wide winch strap. Reel has matching holes drilled in each side plate. Crank the reel so that the hole is outside of the edge of the base, and bolt can be inserted. A wrench or needle-nose pliers are necessary to hold the nut in position on the opposite side during mounting. The bolt goes through a loop in the end of the strap. Powder coated black finish. Handle included. 2000 lb capacity. Straps sold separately, see Hand Winch Accessories. Recommended strap is model 6249, 20 foot, item 24240.

A combination of item 11002 (which will accept strap), and 11001 (which has a hex drive, to be operated with an electric drill). Reel has matching holes drilled in each side plate for mounting strap. Straps sold separately, see Hand Winch Accessories. Recommended strap is model 6249, 20 foot, item 24240. Handle included for when a drill is not available.